Bambu Lab P1S: verschil tussen versies
Naar navigatie springen
Naar zoeken springen
(→FTP) |
|||
| Regel 1: | Regel 1: | ||
== Hardware == | == Hardware == | ||
| − | Dit is een Bambu Lab X1 Carbon, met standaard | + | Dit is een Bambu Lab X1 Carbon, met standaard 0.4mm nozzle. |
| + | |||
| + | Plates: | ||
| + | * Textured PEI Plate. | ||
| + | * Dual-Texture PEI Plate. | ||
| + | * 3D Effect Plate. | ||
== Firewall == | == Firewall == | ||
Huidige versie van 4 jan 2026 om 19:22
Hardware
Dit is een Bambu Lab X1 Carbon, met standaard 0.4mm nozzle.
Plates:
- Textured PEI Plate.
- Dual-Texture PEI Plate.
- 3D Effect Plate.
Firewall
De bambu lab P1S maakt gebruik van UDP broadcast-pakketjes op poort 2021
sudo iptables -A INPUT -p udp -m udp --dport 2021 -j ACCEPT
Troubleshooting
My prints don't stick to the bed
Clean the textured PEI plate with luke warm soapy water and scrub using a brush. https://wiki.bambulab.com/en/filament-acc/acc/pei-plate-clean-guide
MQTT
Using MQTT V3.1.1
mqtts://bblp:{access_code}@{host}:8883only subscribe to
device/{serial}/reportand only publish to
device/{serial}/request
(MQTT Explorer wordt gekicked, gebruik MQTTX en subscribe alleen maar naar de topic die je hierboven ziet)
FTP
ftps://bblp:{access_code}@{host}:990