Bambu Lab P1S: verschil tussen versies
Naar navigatie springen
Naar zoeken springen
(→MQTT) |
(→FTP) |
||
| Regel 24: | Regel 24: | ||
== FTP == | == FTP == | ||
| − | <pre>ftps://bblp:{access_code}@{host}</pre> | + | <pre>ftps://bblp:{access_code}@{host}:990</pre> |
=== More help === | === More help === | ||
https://wiki.bambulab.com/en/p1/troubleshooting | https://wiki.bambulab.com/en/p1/troubleshooting | ||
Versie van 4 jan 2026 17:21
Hardware
Dit is een Bambu Lab X1 Carbon, met standaard de 0.4mm nozzle en de textured PEI buildplate.
Firewall
De bambu lab P1S maakt gebruik van UDP broadcast-pakketjes op poort 2021
sudo iptables -A INPUT -p udp -m udp --dport 2021 -j ACCEPT
Troubleshooting
My prints don't stick to the bed
Clean the textured PEI plate with luke warm soapy water and scrub using a brush. https://wiki.bambulab.com/en/filament-acc/acc/pei-plate-clean-guide
MQTT
Using MQTT V3.1.1
mqtts://bblp:{access_code}@{host}:8883only subscribe to
device/{serial}/reportand only publish to
device/{serial}/request
(MQTT Explorer wordt gekicked, gebruik MQTTX en subscribe alleen maar naar de topic die je hierboven ziet)
FTP
ftps://bblp:{access_code}@{host}:990